Machinist - Manual Mark Andy, Inc.
THIS JOB HAS EXPIRED Mark Andy is seeking a Machinist to perform duties required to set up and operate 15" lathe and inspect parts. If interested, please email your resume and any pertinent information to Mark Andy Human Resources.
Duties include but are not limited to the following
Perform set up on 15" engine lathe, such as: collect required tools, install tools into holders, locate and indicate chuck or install collect, etc.
Using hand tools, blueprint, process sheets, etc.
Operate engine lathe: load material into chuck or collect, machine parts, such as: c'drill, drill, rough and finish bore, rough and finish turn, chamfer, tap, thread, face, knurl, part off, etc.
Unload and deburr part
Inspect parts with micrometers, hole test gauges, calipers, thread and plug gauges, indicators, telescoping depth gauges, etc.
Hold tolerances on diameters and concentricity per print
Complete quality checks as required
Use arbor press to install bearings and surface and wheel grinders to make special tools and to sharpen tools
Collaborate with Foreman and industrial engineers to verify and/or change shop routers and process sheets to facilitate manufacture of parts
Assist engineering department by machining prototype parts and evaluate machinability of parts.
Check and maintain oil and coolant levels, clean out chip pan, clean and oil ways, etc.
Perform other duties as trained/required
Demonstrated ability to perform the tasks listed above
High School degree or equivalent
Minimum 3 years Engine Lathe experience
Plug and thread gauges
Moderate to frequent exposure to shop environment; may be exposed to dust, odors, oils, fumes, chemicals, noise and moving parts. Work typically requires the usage of PPE and can require work on the facility?s production floor or on the production floor in a customer?s facility.
Regularly required to sit, stand, bend, reach, climb, stoop, kneel, crouch and crawl and move about facility and/or customer?s facilities. Frequent lifting up to 50 pounds.
||Chesterfield, MI |
THIS JOB HAS EXPIRED